
Error codes
The following error codes may appear in the timer display (7) if there
is a problem with the operation of the hob.
Fault Possible cause Solutions
FO/F1/F2 Fan failure Contact the Service Department
F3 – F8 Temperature
sensor failure
Contact the Service Department
E1 – E2 Abnormal voltage
from the mains
supply
Check whether the power supply is
operating normally.
E3 – E4 Abnormal
temperature
Check that the pan is of the correct size
to be used on a particular zone. If the
pan is correctly sized and the error code
reappears, contact the Service
Department.
E5 – E6 Poor heat
radiation from a
cooking zone
Allow the appliance to cool down and
then use the cooking zone again. If the
error code reappears, contact the
Service Department.
IMPORTANT: If your appliance appears not to be
operating correctly, then you should disconnect it
from your mains supply and then contact the
Baumatic Service Department on telephone
number (0118) 933 6911.
DO NOT ATTEMPT TO REPAIR THE APPLIANCE
YOURSELF.
Please note that if an engineer is asked to attend whilst the product is
under guarantee and finds that the problem is not the result of an
appliance fault, then you may be liable for the cost of the call out
charge.
The appliance must be accessible for the engineer to perform
any necessary repair. If your appliance is installed in such a
way that an engineer is concerned that damage will be caused
to the appliance or your kitchen, then he will not complete a
repair.
This includes situations where appliances have been tiled in,
sealed in with sealant, have wooden obstructions placed in
front of the appliance, like plinths. Or any installation other
than the one specified by Baumatic Ltd. has been completed.
Please refer to the conditions of guarantee that appear on the
warranty card that you receive with the appliance.
27
Kommentare zu diesen Handbüchern