Baumatic B68.1SS Bedienungsanleitung PDF herunterladen (Seite 31)

ust be carried out by a GASSAFE

registered engineer.

hob from the electricity supply

and/or adjusting the minimum

rner on

the

Remove the knob from

the tap and place a

small bladed

screwdriver in the

o decrease the gas flow.

t is obtained when the flame has a

length of about 3 – 4 mm.

o Refit the control knob.

o Make sure that the flame does not go out by quickly turning

from maximum flow to minimum flow. If it does then remove

the control knob and make further adjustments to the gas

flow, testing it again once the adjustment has been made.

o Repeat this process for each one of the gas taps.

Minimum flow adjustment for hob gas taps.

All work m

IMPORTANT: Always isolate the

before changing the injectors

flow of the burners.

o Switch the bu

and set the knob at

minimum position.

centre of the tap shaft.

o Unscrew the adjusting screw, in order to increase the gas flow or

tighten the adjusting screw t

o The correct adjustmen

o For butane/propane gas, the adjusting screw must be tightly

screwed in.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Keine Kommentare

Baumatic B68.1SS Bedienungsanleitung Seite 31